Hey folks,
This is a technical one where I'm not sure of the correct macro.
Situation:
K3s, Remote via RRC 1258, using the serial connection.
However, we want an alternate remote that is supported by N1MM on the
desktop.
Therefore, I want to be able to switch between USB and RS-232 ports for rig
control.
When on the Remote, I can just use the K3/0 menu to switch to USB, at which
time I'll
lose rig control.
Then, using Anydesk/Teamviewer/etc ... I can connect N1MM on the remote PC
and play radio over the USB port.
However, I won't have a way to set the rig back to RS-232 38400 to use
RemoteRig again...
Solution?
However, there seems to be the RS232 MN057; macro, which gets you to the
RS232 menu setting. I'm just looking for the right sequence to go either
direction; obviously, I'll need to be connected on the right port to move
control back
And... I'll only test this when I'm local in the station! :-)
Any help appreciated.
73,
Gerry W1VE
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
