Missing (2) 3/4" Long Spacers?

[Fred (FL)]

I'm building K2 #5422, doing Front Panel board now!

I seem to be MISSING the two (2) 3/4" (19mm) LONG
SPACERS mentioned on page 26, for putting over leads
of each backlight LED shown in figure 5.9?

No were to be found, as far as I can see.  WHAT DO
THEY LOOK LIKE?  Paper?  Plastic?

There are no "spacers" mentioned in appendix of
photos for this front panel board either?

Help
Thanks, 73's
Fred N3CSY
Spring Hill, FL

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around
http://mail.yahoo.com 
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Nick Waterman]

F and J wrote:
> I seem to be MISSING the two (2) 3/4" (19mm) LONG
> SPACERS mentioned on page 26, for putting over leads
> of each backlight LED shown in figure 5.9?
>
> No were to be found, as far as I can see.  WHAT DO
> THEY LOOK LIKE?  Paper?  Plastic?

Aren't they the ones made out of little strips of PCB? I think they come
attached to the RF probe board, each one is just a little strip of PCB
with 2 holes in? It's used for switch-spacing first, then you break them
off and stick the LED leads through to use as the LCD spacers?

--
"Nosey" Nick Waterman, G7RZQ, K2 #5209.
use Std::Disclaimer;    [hidden email]
Sweater, n.: A garment worn by a child when its mother feels chilly.
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com