More about copying code ...

[Ken G Kopp]

If one is "good" at code it's like knowing a second language.  Copying in a
"pileup" is like following a particular conversation in a room full of
chattering people.

Many do better ... are faster ... at copying using longhand, finding it's
faster than printing, but this is more related to writing / printing skills
that have nothing to do with code copying skill.

FWIW ...

Trivia:  There are 50+ "Kopp" hams.

73

Ken
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Ronnie Hull]

just turned on my KPA1500 to check into a Ten Ten International net, and
when I put it in Operate Mode I had a Fault light, and the displayed showed
that the HV ( 50V ) was only 9.6volts.  I tried turning off the Amp and the
Power supply several times to no avail. Finally I just unplugged the power
supply for a few minutes. Plugged it back in and fired the ps and amp back
up and all was normal. WHEW.. glad for that but.. WHY did it do this?

thanks and God bless

Ronnie W5SUM

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Bob McGraw - K4TAX]

Sounds like a power glitch.  I’ve seen that with my KPA500.   My amp is powered from a 240v line w/neutral.  As to why unplugging was necessary, I can only speculate primary leakage current or line input filter, which is in the microamp range, was a contributing factor.

Bob, K4TAX


Sent from my iPhone

> On Dec 26, 2019, at 7:52 PM, [hidden email] wrote:
>
> just turned on my KPA1500 to check into a Ten Ten International net, and when I put it in Operate Mode I had a Fault light, and the displayed showed that the HV ( 50V ) was only 9.6volts.  I tried turning off the Amp and the Power supply several times to no avail. Finally I just unplugged the power supply for a few minutes. Plugged it back in and fired the ps and amp back up and all was normal. WHEW.. glad for that but.. WHY did it do this?
>
> thanks and God bless
>
> Ronnie W5SUM
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [hidden email]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]