My display problem :)

[Clark Ward]

Thanks to you guys who've replied.  I forgot to mention that the backlight
works.  I tried resetting the radio (i.e. holding down 4,5, & 6 while turing
the K2 on) and the display shows "Info 201". So, something inthere works.
 But still get nothing other than that.
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

Clark,

If you have any display at all, even INFO 201 then the Fromt Panel may be
OK.  That means the problem is likely on the Control Board or at the
connectors to the RF Board - and the most likely source of the problem is a
bad solder connection.  Soldering problems are the most common form of
failures.
Check the soldering, then re-check the soldering, and when you have finished
that, check the soldering!

73,
Don W3FPR

> -----Original Message-----
>
> Thanks to you guys who've replied.  I forgot to mention that the backlight
> works.  I tried resetting the radio (i.e. holding down 4,5, & 6
> while turing
> the K2 on) and the display shows "Info 201". So, something inthere works.
>  But still get nothing other than that.
>

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com