N-Gen

[Bill Scovell]

A signal from Down-Under.
What dc voltage should I expect at the output pin of the MAR-1? --- more than a fraction of a volt I suspect.
Generator was previously OK now seems to be noiseless!

TIA   Bill Scovell/VK4SQ
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Nigel A. Gunn G8IFF/KC8NHF]

I would expect around 5-6 volts.

Bill Scovell wrote:

>A signal from Down-Under.
>What dc voltage should I expect at the output pin of the MAR-1? ---
>
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
Nigel A. Gunn. 59 Beadlemead, Milton Keynes, MK6 4HF, England.
Tel [phone]       mobile [phone]
e-mail [hidden email]             www  http://www.ngunn.net 
Amateur radio stations  G8IFF, KC8NHF
Member of  AMSAT-UK #182, ARRL, GQRP Club, QRPARCI, SOC #548,  RAYNET
           Flying Pig #385, Dayton ARA #2128, AMSAT-NA  LM-1691,  MKARS
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com