N1MM and K3

[Richard Meilstrup]

I need som advice to get my new K3 and N1MM work properly.  Only problem
left is this:  *I cannot make N!MM key the K3*. My PC (XP) has serial ports
and I use one of them. Will somebody out there tell me what to do?
Rick, OZ5RM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Iain MacDonnell - N6ML-2]

Richard Meilstrup wrote:
> I need som advice to get my new K3 and N1MM work properly.  Only problem
> left is this:  *I cannot make N!MM key the K3*. My PC (XP) has serial ports
> and I use one of them. Will somebody out there tell me what to do?

Hi Rick,

Assuming already have the serial port for "rig control" and want to key
through the same port...

On the K3, set "CONFIG:PTT-KEY" to "rts-dtr"

In N1MM Configurer, Hardware tab, click "Set" for the appropriate serial
port, and set "DTR" to "CW" and "RTS" to "PTT".

Back at the Hardware tab, check the "CW" box for the port you just
configured.

That should do it...

     ~Iain / N6ML


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[k6dgw]

Richard Meilstrup wrote:
> I need som advice to get my new K3 and N1MM work properly.  Only problem
> left is this:  *I cannot make N!MM key the K3*. My PC (XP) has serial ports
> and I use one of them. Will somebody out there tell me what to do?
> Rick, OZ5RM
>

I don't have my K3 right now [in the Elecraft shop], but there is a menu
item [CONFIG:RS232?] where you can select DTR and RTS for PTT and CW
keying. Pick your choice, write it down, then go to N1MM and in the
Configure menu item, choose the top one [Ports].  Select the COM port
you're using, check CW, and put the DTR/RTS settings in the appropriate
fields.  Works like a champ.

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2009 Cal QSO Party  3-4 Oct 2009
- www.cqp.org
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Greg - AB7R]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html