Need help wid KRC2 config utility

[Marcus Busch [DL1EKC]]

Hi folks,

today I found the KRC2 config utility on the Elecraft homepage. Happily I prepared for
configuring my KRC2 by software rather than by hardware. However, I cannot write my mapping to
my KRC2.

I have:

- WinXP SP2
- USB to COM converter (which runs fine for PC control and other stuff)
- KRC2 with firmware V1.3
- OP/DL switch set to DL
- ext. power supply connected to KRC2
- straight thru V24 cable
- K2 disconnected from the KRC2

Issue 1:

When I push "Test for KRC2" it returns "KRC2 V1.3". But when I hit "Send to KRC2" the utility
responds "Last send failed" and my KRC2 locks up. To get it back to life I have to cycle power.
My USB/V24 adapter has data LEDs and I can see data traffic in both directions before the "Last
send failed" message comes up.

Issue 2:

When I want to open the analog voltage tables the utility tells me "Run time error '713': class
not registered. You need the following file to be installed on your machine. MSSTDFMT.DLL."
Where can I get this DLL ?

Maybe someone can help me with these issues ?

VY 73 de Marcus, DL1EKC

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Thomas Butchers]

> -----Original Message-----
> From: [hidden email] [mailto:elecraft-
> [hidden email]] On Behalf Of Marcus Busch [DL1EKC]
> Sent: Sunday, May 20, 2007 1:40 PM
Marcus, first try searching on your PC for the DLL it may be there but not
running. If that fails you can download it from several places on the net;
here is one place to get it:

http://www.dll-files.com/dllindex/dll-files.shtml?msstdfmt

Sorry I can't help with the other issue...

Tom kf4yyd



> To: Elecraft Mailinglist
> Subject: [Elecraft] Need help wid KRC2 config utility
 

> Issue 2:
>
> When I want to open the analog voltage tables the utility tells me "Run
> time error '713': class
> not registered. You need the following file to be installed on your
> machine. MSSTDFMT.DLL."
> Where can I get this DLL ?
>
> Maybe someone can help me with these issues ?
>

No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.467 / Virus Database: 269.7.6/813 - Release Date: 5/20/2007
7:54 AM
 

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com