Scenario:-
K2 / 4313 Alignment and Test Part #1.
1) Last item on page 42 --- everything per the manusl except the Pre-amp annunciator is also displayed.
Pre-amp and Attenuator toggle OK but Pre-amp annunciator always present upon 'switch on' regardless of setting at 'switch off' --- is this a problem?
2) All OK through page 46 up to 'Audio Amplifier and Tone Generator Test' --- NO SIDE TONE!! --- referred to 'Appendix E' page 12 --- could not detect any signal at pin 25 of U6.
Looking for advice on the least destructive way to proceed.
TIA, Bill Scovell / VK4SQ
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
