Lou,
The encoder itself is the same one used in the K3/K3S, so I think if
there was a bad batch of encoders in the Elecraft stock, it would have
been noticed and quickly corrected.
However, the board to convert the pulse count of that encoder to that
needed by the K2 is suspect in my mind. It is 'firmware' and I suspect
that there may have been some unprogrammed ICs made their way into the
K2 encoder assembly packages. Of course, that remains to be proven, it
is just a guess on my part.
Continue to work with support, it should be resolved soon.
73,
Don W3FPR
On 8/5/2018 8:07 AM, Lou Voerman W2ROW wrote:
> I am building a newly acquired K2. Everything was fine through stage 1
> assembly and checkout. Upon reassembling after stage two the main tuning
> encoder no longer works (turning the knob does absolutely nothing). I
> contacted Elecraft support and Gary sent me a new encoder assembly. I
> received it yesterday, assembled it and installed it, it also does not work.
> At every stage I flush cut the leads on both the encoder PCB and the control
> board and insulated with thick paper.
>
> To add to the plot, I have an older K2 which I disassembled and removed the
> encoder assembly from. I installed that encoder assembly in the new K2 and
> it works FB. I also installed one of the new encoder assemblies in the old
> K2 and it does not work (as expected).
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
