Hi Mike, What is CONFIG:TX DLY set to? 73, Guy.
On Fri, Jun 8, 2012 at 12:41 AM, Michael Marx <
[hidden email]>wrote:
> Hey all,
>
> I just built my new K3-100. All seems to be fine except when I try to
> use CW QRQ mode. When I select this mode, I only have about 5 watts of
> power output no matter where the power setting is. Elecraft says that the
> CW QRQ mode has nothing to do with power output, yet I have the problem. I
> am using the built in wattmeter and an external wattmeter. When I switch
> CW QRQ off, the power comes back to full. I did a reset at Elecraft's
> recommendation and it did not resolve the problem. I also loaded the
> newest firmware (which it should have had anyway) and no solution to the
> problem. Any ideas out there
>
> 73,
> Mike WB0SND
>
> Michael Marx
>
[hidden email]
>
> www.vacuumtubes.com
> SND Tube Sales
> 105 N. Division St.
> Bonne Terre, MO 63628
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
