I'm attempting to use my K3 for the first time. I *think* I completed all
calibration steps as per the manual (synthesizer, TXCO 1ppm, Tx gain). I
hooked up the K3 to my antenna this morning and tuned to 10 MHz. WWV came
in just fine and clearly understandable on LSB or USB. However, I seem
unable to tune in SSB signals on other bands, such as 20 or 40. The signals
are distorted. Perhaps I have missed something in the initial setup, or I
need to activate something. I've tried adjusting the Shift/Width/Hi Cut/Lo
Cut knobs to no avail. I'm using the KAT3 to tune my dipole. Filters: 2.7k
5-pole, 1.8k 8-pole, and .400k 8-pole.
Trying to work my way through the manual, but I'm a little lost right now.
Will try again later tonight after work.
Suggestions?
Thanks!
Jeff, W6EZY
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html