The TMP cables can be tricky to insert. Make sure all of them are
plugged in all the way. Since you swapped the synths, the problem is
likely on the ends of the cables that do not go to the synths.
You have probably checked and double checked the locations of all the
cables against the diagram in the instructions, but I would do it again.
The symptom suggests that they are not hooked up correctly.
It might be worth checking the ends of the cables carefully to make sure
they are OK.
73,
Vic, 4X6GP/K2VCO
Rehovot, Israel
http://www.qsl.net/k2vco/On 22 Apr 2015 14:07, Jim wrote:
> Sometimes you wish you had left well alone!
>
> I installed the new KSYN3As this morning. Uploaded the new firmware
> to 5.14 as instructed.
>
> Now here is the problem. VFO A will NOT tune. VFO B does. Swapped
> the cards over just in case. Reloaded firmware just in case. Still
> get the same VFO A not tuning but VFO B does. Guess that removes any
> issues with the boards. Have found that if you go into Configure you
> can’t change settings either.
>
> Any suggestions as to what I can do next?
>
> 73 Jim G3RTE
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
