Was recently troubled by no output on my K2. It was
doing fine then the output failed after loosing a nut
on the heat sink.
Current idled at about 48 ma on transmit. Replaced
the finals and associated hardware but the problem
remained. Problem turned out to be a cold solder joint
on T1 which may have been aggravated by the heat sink
failure, So I'm now ready to check in to my first
Elecraft Net !
73
Gary AA1UE
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
