No Speaker output

[Carsten Steinhöfel]

Hi there,

I have a little problem with K3 #549. I do not get AF out of the internal Speaker
or rear-panel Speaker output. I am usually using headphones so only noticed it
recently in Senegal when I wanted to have my YL listen to a sked with home.

It doesn't seem to be a hardware problem because when I set SPKR+PH to yes in the
menu I do get output. Only if it is set to no and I don't have headphones connected
is there no output. I've tried setting SPKRS to 1 and 2 with no difference. Is
there some other setting that I am missing that could be causing this behaviour?

I've also tried upgrading to the latest firmware but that didn't make a difference
either.

I'd be grateful for any ideas.

Thanks and regards,

Carsten, DL1EFD

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[S Sacco]

Carsten -

 

I am experiencing the same problem.  At this point, after confirming that it's not the KAIO3 boards, Elecraft suspects a bad DSP board, and they're sending me a replacement.   I'm hoping this resolves the problem.

 

Good luck & 73,

Steve NN4X

 

On Tue, Dec 9, 2008 at 5:34 AM, Carsten Steinhöfel <[hidden email]> wrote:

Hi there,

I have a little problem with K3 #549. I do not get AF out of the internal Speaker
or rear-panel Speaker output. I am usually using headphones so only noticed it
recently in Senegal when I wanted to have my YL listen to a sked with home.

It doesn't seem to be a hardware problem because when I set SPKR+PH to yes in the
menu I do get output. Only if it is set to no and I don't have headphones connected
is there no output. I've tried setting SPKRS to 1 and 2 with no difference. Is
there some other setting that I am missing that could be causing this behaviour?

I've also tried upgrading to the latest firmware but that didn't make a difference
either.

I'd be grateful for any ideas.

Thanks and regards,

Carsten, DL1EFD

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Ignacy]

I also have the same problem and getting a new DSP board.
Ignacy

S Sacco wrote

Carsten -

I am experiencing the same problem.  At this point, after confirming that
it's not the KAIO3 boards, Elecraft suspects a bad DSP board, and they're
sending me a replacement.   I'm hoping this resolves the problem.

Good luck & 73,
Steve NN4X



On Tue, Dec 9, 2008 at 5:34 AM, Carsten Steinhöfel <
[e-mail]> wrote:

>
> Hi there,
>
> I have a little problem with K3 #549. I do not get AF out of the internal
> Speaker
> or rear-panel Speaker output. I am usually using headphones so only noticed
> it
> recently in Senegal when I wanted to have my YL listen to a sked with home.
>
> It doesn't seem to be a hardware problem because when I set SPKR+PH to yes
> in the
> menu I do get output. Only if it is set to no and I don't have headphones
> connected
> is there no output. I've tried setting SPKRS to 1 and 2 with no difference.
> Is
> there some other setting that I am missing that could be causing this
> behaviour?
>
> I've also tried upgrading to the latest firmware but that didn't make a
> difference
> either.
>
> I'd be grateful for any ideas.
>
> Thanks and regards,
>
> Carsten, DL1EFD
>
> _______________________________________________
> Elecraft mailing list
> Post to: [e-mail]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>

_______________________________________________
Elecraft mailing list
Post to: [e-mail]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com