This didn't seem logical or possible to me. So I tried it and discovered
the problem occurred on 6m, but not on 80m with my K3 and firmware 5.64.
Interesting. This K3 (S/N 08343) has a recent EE INIT and re-load of
firmware and configuration after experiencing a power overshoot issue (now
solved).
73, Bill, K8TE
President, Albuquerque DX Assn.
ARRL NM SM (elect)
Duke City Hamfest BoD
www.dukecityhamfest.org
Faith, Family, Radio-Life is Good!
>
>> On Nov 16, 2017, at 3:50 AM, Michael Eberle <
<
http://elecraft.365791.n2.nabble.com/user/SendEmail.jtp?type=node&node=7635987&i=0> [hidden email]> wrote:
>>
>> Was this issue ever resolved? I have noticed the same thing with mine
>> although the issue does not appear to be the tuner itself, but the K3 is
not
>> transmitting any power so the tuner has nothing to work with. I am
running
>> FW version 5.60 an have this issue but only on 6 Meters.
>>
>> I can power up the K3 and open WSJT-X on my computer and select 6 meters
>> which usually causes SPLIT to turn on. Hold TUNE and the TX keys and the
>> display shows 0 power. Turn off SPLIT and it puts out power as usual.
Then
>> if I turn SPLIT back on, it will then output a carrier as usual.
>>
>> If SPLIT is enabled on 6 meters and you run a TX gain calibration, it
will
>> fail the calibration because the TX puts out no power.
>>
>> It's not a major issue but an annoyance since I tend to forget about it
>> every time I switch from HF to 6 and try to check my antenna tuning.
>>
>> Thanks,
>> Mike, KI0HA
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
