Thanks very much for the helpful suggestions on how to solve the
no power output in the final assembly Part III. W3FJP provided
a very detailed test procedure and a number of others provided info
about how they solved similar problems. The RF probe showed low
output from the Buffer. Using a magnifying lens I found what
appeared to be a tiny hint of a pool of solder around RFC13.
After touching it up, all is well with full output power. I also
found my trusty 35 yrs old 2kw dummy load had a bad coax fitting.
Even though I was up half the night, it was worth the effort!!!
Frank W7is
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
