Hi Jerry,
The red light after end-of-tune-up indicates a high SWR. This would
normally not cause any problem with the T1 since it has bypass
capacitors on all of the microcontroller leads. But you could have a
case of extreme RFI; it could be caused by a ground loop, or even a VHF
or UHF oscillation in the radio. Unusual but not impossible.
What power level are you using? You might try doing tune-ups at 2 watts
to see if your difficulties are proportional to power out.
I've also asked Gary in our CS department to help you with this.
73,
Wayne
N6KR
On Nov 9, 2006, at 3:45 PM, nr5a wrote:
> First a couple of weeks ago I managed to blow the diodes in the KAT-2
> for the 2nd time. I have not been on the air for about a week and just
> got out my T-1. Replaced the battery with a fresh one. Atempted to
> tune on 20m, get the flashing green lite key down stays on red till I
> let off the key then the green lite flashes for another 2 minutes or
> so. Does this both on my vertical and G5RV. Rig has been completely
> disconnected for a week.
>
> What the heck am I doing wrong? Now I'm really getting frustrated.
---
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
