Optical Encoder problem:

[n9bx-2]

Still no adjustment, or frequency change.

In the Elecraft Manual page 108 under Front Pnel Board, 4th paragraph  
down it says.  "The Encoder can be turned off By U3 to save current  
under certain operating conditions".  Does any one have any Idea what  
this means?  And also how would you try and turn it Back On.

73 Bruce N9BX

--------------------------------------------------------------------
This message was sent via the WishCom Webmail system, a free service
offered to subscribers. http://www.wishcom.net


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

While this is a fact, it is not under user control.  Do not be concerned
about it.  The firmware should reactivate the encoder when it is moved.

73,
Don W3FPR


> -----Original Message-----
>
> In the Elecraft Manual page 108 under Front Pnel Board, 4th paragraph
> down it says.  "The Encoder can be turned off By U3 to save current
> under certain operating conditions".  Does any one have any Idea what
> this means?  And also how would you try and turn it Back On.
>
> 73 Bruce N9BX
>

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com