Hi Paul,
I think what you're asking is why the P3's VFO B cursor flashes when you
tune the VFO A cursor rapidly That is caused by the fact that the VFO
B cursor does not update as rapidly as the VFO A cursor. There are a
couple solutions:
- Unlink the VFOs on the K3 by holding the SUB button.
- Turn off the VFO B cursor in the P3 via MENU: VFO B
Alan N1AL
On Wed, 2012-06-20 at 14:28 -0400, Paul VanOveren wrote:
> I must have changed something in the configuration of my P3... With the cursor type set as “bar” and in the the “finest” rate, 3 # to the right of the decimal, everything is fine. In the next coarser rate, 2 # to the right of decimal, I get a line, like the B marker is on, on the left edge of the curser. In the coarsest rate, 1 # to the right of the decimal, if I tune the A VFO rather rapidly, I get flashing B marker lines, above and below the center frequency curser..
> Maybe what I am asking is how to shut the Purple VFO cursor off, it moves with either the A VFO or the B VFO..
>
> NF8J
> Paul
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html