P3 - Control from Python Gui

[Tim Seed]

Fellow Hams,
        I have found time to update the P3 Controls - it is now fully GUI - and you can have any type of split (not negative !!) with a p3 bandwidth of up to 10Khz, with the carrier at any offset you want from (0-5khz)

        The code is in my github page at https://github.com/timseed/Elecraft-K3-Pan-Pile-Up-Settings <https://github.com/timseed/Elecraft-K3-Pan-Pile-Up-Settings>

        It now however requires QT5 (which can be troublesome on certain days of the week to install) - but once installed - a few more packages (numpy, pyserial, guidata) and you are done.

        If anyone requires any assistance with this - please PM me off-list.

        Regards

                Tim - A45WG


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]