Thanks for the replies.
Nothing truly 'fatal' about the error message I got; after I corrected the
source of the problem (I failed to tighten the DB9 retainer screws and
bumped the wires) it was quite simple to cycle the power and hold certain
buttons down to effect a reset.
I did lose my settings, however. Unlike the K3, which has a config file,
the P3 currently does not appear to.
No worries, it only takes about 4 minutes to re-set the function buttons
and so forth.
Steve KZ1X/4
... going back to see if the 7O6T log web page has been updated ...
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
