Thanks Ron.
peh
On Aug 6, 2010, at 10:23 PM, Ron D'Eau Claire wrote:
> Hi Phil:
>
> Here are the changes:
>
> Corrected Resolution Bandwidth to "Span / 450, 8 Hz minimum" on page 8.
>
> Added Operating Tip to Parameter Initialization on pg 21 emphasizing that FN
> key assignments are erased and MENU entries are returned to the defaults
> shown on page 20.
>
> Fixed typo in fourth bullet on pg 21.
>
> Moved knob from Front Panel envelope to the Chassis Hardware envelope in the
> Parts List pg A-2.
>
> Added instruction to gently push the LCD panel into the rubber matrix as
> needed so it is fully seated Assembly Procedure pg B3.
>
> Added specific instruction to place the serial number label on the rear
> panel under the IF IN jack.
>
> Ron AC7AC
>
> -----Original Message-----
> From:
[hidden email]
> [mailto:
[hidden email]] On Behalf Of Phil Hystad
> Sent: Friday, August 06, 2010 8:32 PM
> To: Elecraft Reflector
> Subject: [Elecraft] P3 Owner's Manual
>
> I read the owner's manual that came with my P3 but then realized that it had
> been updated. My original was A1 and I just downloaded the A2 copy and I am
> printing it. I also downloaded the errata to A2.
>
> So, does anyone know what changed between A1 and A2?
>
> 73, phil, K7PEH
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
