While working the NAQP CW contest this afternoon, I noticed that the TX Monitor was not always indicating the correct power or SWR. Also the waveform was not always displaying properly (sometimes is is just a a wavy line instead of the usual waveform).
I took the cables off the P3 and the sensor box and reset everything. I also refreshed the firmware in the P3 just because, but still have the same issue.
I did put a second wattmeter in-line ahead of the P3 sensor and confirmed that my power out and SWR is ok.
This is happening on various bands and antennas. I have not tried phone today, just CW.
Anyone seen this before?
Mike - KI8R
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
