I've just reassembled my double K-line station after a move. Everything
is working properly with the exception of one of my P3s. When I attempt
to power it up, I just see a rapidly flashing boot loader message for a
few seconds and then it turns off. This happens with or without
connection to the external RS232 or IF jacks. It does have a SVGA board
installed. The problem persists if it is powered from either of my two
K3s (which run from different power supplies).
I'm sure I'll have to open the thing up and check for connectivity
problems, but I thought I'd ask first if anyone has observed this
problem and might know what's going on to help shortcut the
troubleshooting process. It's a bit of a pain to remove the P3 from the
station setup, so I'd like to do it only if necessary.
73...
Randy, W8FN
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
