P3: s/n 464 Firmware 00.32 Rcvd 9/14/10
K3: s/n 4521 Firmware 4.10 Rcvd 8/2/10
I have an old logging program that I do not want to lose or have to change.
My first problem, because this program is so old (YPlog) was solved by
selecting a Kenwood TS570D as the xcvr and setting the baud rate at 4800/1
stop bit. That works fine.
Today, W4TV published an email explaining how to reset the P3 baud rate from
its default of 38,400 back to 4800. That works. Unfortunately CONFIG:RS232,
when I change the baud rate from 38400 to 4800 and press MENU/CONFIG again,
the baud rate change is not saved in the K3 and I can no longer connect to
my logging program. The only work-around I have found so far is to turn off
the P3, set the K3 CONFIG:RS232 from 38400 to 4800, then press MENU/CONFIG,
then turn the P3 ON again, and all works correct.
Will there be a firmware update that will allow the P3 and the K3 to be set
at baud rates other than 38400 when BOTH the K3 and the P3 are turned on? I
certainly hope so because this YPlog is the only logging program I have
found in some 20 years that will allow me to send CW at speeds over 60 wpm
without the CW stuttering due to I/O interrupts from a CPU.
Thanks and 73,
Tom - W4BQF
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
