P3 settings issue

[Gary Gregory-2]

Things have been going well until 'Fat Fingers' decided to press buttons.

Is there an easy way to set the P3 to default settings other than sing the
utility?

Busy in a contest and would like to not have to disconnect the logging from
the K3 to fire up the utility.

73

Gary

--
*Gary - VK1ZZ
Skype: Gary.VK1ZZ
Motorhome Portable
The Shack*
*Elecraft K3
P3 Panadapter
KPA500FT
KAT500FT**
KX3-K
*
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Alan Bloom]

You can do a "Parameter Initialization" as described in the
Troubleshooting section of the manual.  Basically, you hold the LABELS
key while turning on the P3 with the POWER switch.  Wait until the
"CONFIGURATION RESET" message appears on the screen and release then
release the LABELS key.  If you have the power-on jumper in the P3
configured to always-on, then just hold LABELS and tap POWER.

Alan N1AL


On 6/8/2013 8:07 PM, Gary Gregory wrote:

> Things have been going well until 'Fat Fingers' decided to press buttons.
>
> Is there an easy way to set the P3 to default settings other than sing the
> utility?
>
> Busy in a contest and would like to not have to disconnect the logging from
> the K3 to fire up the utility.
>
> 73
>
> Gary
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html