The K3 inverts the IF on all bands except 6 meters. But the P3 is
supposed to take that into account and display the spectrum with the
proper orientation.
If it's not doing that, then it sounds like the RS-232 communications
between the K3 and P3 may have failed for some reason. Does the K3 VFO
frequency display correctly on the P3?
Alan N1AL
On 05/31/2017 10:21 AM, tony leonardini via Elecraft wrote:
> A upper sideband signal show up on the lower side & a lower sideband signal shows up on the upper side. Dose not matter which ssb side is selected on the K3 the transmit signal is reversed. All other bands display the correctly in the water fall.
> Have a K3s /P3 and K3 /P3, ALL setting on both K3’s/P3’s are the same.
> Do not know when this started just noticed it on this last 6m opening, this K3 normally has either the main or sub setting on 6m.
> Any ideas would be greatly appreciated wa6qmq
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
