Absolutely. Go into the K3 Utility on the Command Tester/K3 Macros
tab. Click the 'Edit Macros' button. Type a label for the macro in the
Macro Label field. In the Macro Commands, use the command TE followed
by a numerical value for each EQ setting (i.e. 50, 100, 200,
400...etc). For example, TE-12-10-06-02+00+06+08+10;
This will set 50 Hz to -12db, 100 Hz to -10db, 200 Hz to -06db... etc.
Don't forget to enter the ; at the end. Save your macros and then send
them to the K3 using the 'Write Macros 1-8 to K3' button. Then go into
the K3 CONFIG menu and select 'MACRO 1' with the VFO B knob. Then hold
PF1 down for a second or two and it will assign macro 1 to PF1. Then
press 2 on the keypad to switch to MACRO 2. Hold PF2 and it will assign
macro 2 to PF2.
If you want, you can also specify mic gain and compression settings
along with the TX EQ commands. MG014; will set mic gain to 14 and CP12;
will set compression to 12. You enter it in the macro command with the
EQ settings as follows: MG014;CP012;TE-12-10...+08+10;
73
Mike - KI0HA
On 2/5/2015 04:27, Mike VE3YF wrote:
> Hi:
>
> I haven't tried my hand at doing some programming yet, but wondering
> if it is possible to set the PF1 and PF2 for TX EQ Audio settings.
>
> I would like to set PF1 for one set of TX EQ Settings (Working DX) and
> set PF2 for another set of TX EQ Settings (Ragchew). This way I
> can alternate between PF1 and PF2 for my desired settings instead of
> manually changing the TX Equalizer.
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
