I just finished the PLL mod board, working through the RF board construction on K2 #5945. I made the solder pads on the back of the small board as small as I can and even then it looks like they'll touch the capacitor that is right behind that board. Makes me think a shot of silicone in there might be prudent. Same on the U6 side, everything is extremely close there.
Thoughts? Did any of you use some sort of insulation there?
Thanks,
-Jeff KA6LAF
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
