PTT Signal Question

classic Classic list List threaded Threaded
3 messages Options
Reply | Threaded
Open this post in threaded view
|

PTT Signal Question

Kevin Shaw
I'm in the process of designing a USB interface board for my K2 and I have a
technical question concerning the "/DOT-PTT" signal in the K2. The signal
goes into Port D of the PIC processor. PTT is grounded when the microphone
is keyed yet I don't see a pull-up resistor on the signal. I believe Port B
of the PIC has internal pull-ups but not Port D. Is there a pull-up on that
signal somewhere on the schematic that I'm missing?

 

Thanks,

 

Kevin

N8IQ

 

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply | Threaded
Open this post in threaded view
|

Re: PTT Signal Question

Jim Younce
Kevin:

Look on Page 1 of  1 of the Control Board on the bottom of the page
Connector P3 Pins 17 & 18 are tied to 5 Volts through 82K resistors in RP4
(5&6 7&8) .

73
Jim Younce K4ZM
K2  SN: 18


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply | Threaded
Open this post in threaded view
|

RE: PTT Signal Question

Kevin Shaw
Ah! I see it now. Thanks Jim.

Kevin
N8IQ


-----Original Message-----
From: k4zm [mailto:[hidden email]]
Sent: Monday, March 13, 2006 2:06 PM
To: elecraft@Elecraft List; Kevin Shaw
Subject: Re: [Elecraft] PTT Signal Question

Kevin:

Look on Page 1 of  1 of the Control Board on the bottom of the page
Connector P3 Pins 17 & 18 are tied to 5 Volts through 82K resistors in RP4
(5&6 7&8) .

73
Jim Younce K4ZM
K2  SN: 18



_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com