PX3 Question

[Terry]

I recently built a PX3 and was going through some of the learning process.
I was changing FixTrack and FixMode settings and I am not sure what I did,
but in either FixTrack setting, the signals seemed to converge from both
directions to the cursor, and when they did, I was tuned to a CW signal.
Whatever I tried to change with the above settings did nothing to change
that behavior.  I finally did a menu reset, and the problem went away.  I
have the latest firmware on the PX3.  I have no idea what I did, but I would
appreciate it if someone could tell me what setting combination I might have
been in to cause the signals on the scope to converge to the cursor from
both sides.

 

Thanks and 73's,

 

Terry, N7TB

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]