Paartially Assembled K2 in Limbo

[Louis C LaCour Jr]

Hello All:

I started to build a K2 a ways back, and since then have lost some of the packs of components (e.g. The resistors listed on p.48, Assembly Part II.

I have completed the build up through and including Part I, but now I don't know that I can finish it. Can the basic components be re-ordered? Or perhaps I should just sell it as-is to to someone for parts. The front panel and control board are finished and test out fine.

I’m really stuck on where to go with this project. I hate abandoning it, but re-collecting missing components may be just too much time investment to justify.

Any ideas whatsoever would be appreciated.

Louis
KE5GIU



[http://arwebserver.arlaw.com/images/arlogosig.jpg]<http://www.adamsandreese.com/>
Baton Rouge | Birmingham | Columbia | Houston | Jackson | Jacksonville | Memphis | Mobile | Nashville | New Orleans | Sarasota | St. Petersburg  | Tallahassee | Tampa | Washington, D.C.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Don Wilhelm-4]

Louis,

Contact Elecraft ([hidden email]) and ask if you can obtain the bags
of parts for the K2 RF Board.
Unless you have a goodly stock of resistors and capacitors, that is
likely to be the less expensive that ordering the parts one at a time.
The only caution I can give is that some parts have changed recently, so
download the latest manual and errata and build the RF Board from that -
do not ignore the errata, mark up the manual with the changes.

73,
Don W3FPR

On 7/20/2015 4:08 PM, Louis C LaCour Jr wrote:
> Hello All:
>
> I started to build a K2 a ways back, and since then have lost some of the packs of components (e.g. The resistors listed on p.48, Assembly Part II.
>
> I have completed the build up through and including Part I, but now I don't know that I can finish it. Can the basic components be re-ordered? Or perhaps I should just sell it as-is to to someone for parts. The front panel and control board are finished and test out fine.
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]