After (or before) activate bset and put the pre-amp where you want it, the switch off bset. The preamp will stay on, but you only have the indication when you activate bset.
Willis 'Cookie' Cooke
K5EWJ
________________________________
From: Gary Smith <
[hidden email]>
To:
[hidden email]
Sent: Wed, February 24, 2010 3:42:22 PM
Subject: [Elecraft] Pre for the Rx ant only?
when I am using my Rx ant into the sub receiver, I click sub and then
hold Rx-ANT till it says AUx. I have my beverage connected to the BNC
port below ANT2.
If I want to have the K3 preamp on for this Rx antenna but not have
it on for the Inverted L, how do I engage the second receiver so it
alone has the preamp engaged? I don't want the noise from my transmit
antenna amplified.
I am mostly working diversity.
Thanks,
Gary
KA1J
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
