Printing Quickstart Guide

[w7aqk]

For some reason my computer is choking on printing the first page of the
Quickstart Guide (the K3 pictorials).  Anyone else having this problem?
Maybe I don't have the right version of Adobe Reader?

As an aside, I snagged Vic, K2VCO, last night on his "beta" K3 on 40 meters.
Sure sounded good!  I also heard him tell the station he worked before me
that all the beta testers had received assembled units (so the staff could
practice assembly), but that one beta tester had disassembled and then
reassembled his beta K3.  Why?  Because he was apparently going to be
involved in the manual preparation!  Makes sense.  I'm guessing I know who
that might be too, although Vic didn't identify the person.  Isn't Ron,
AC7AC, the one who does a lot of that???

Dave W7AQK


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Tom Hammond-2]

At 07:48 09/20/2007, Dave Yarnes wrote:
>As an aside, I snagged Vic, K2VCO, last night on his "beta" K3 on 40
>meters. Sure sounded good!  I also heard him tell the station he
>worked before me that all the beta testers had received assembled
>units (so the staff could practice assembly), but that one beta
>tester had disassembled and then reassembled his beta K3.  Why?
>Because he was apparently going to be involved in the manual
>preparation!  Makes sense.  I'm guessing I know who that might be
>too, although Vic didn't identify the person.  Isn't Ron, AC7AC, the
>one who does a lot of that???

Yep.. Ron did it so he could write the manual. I'm not certain he has
his K3 COMPLETELY back together yet...heheh!

I also took my K3 down to the nuts 'n screw level... well... someone
(me) had to Field Test the Assembly Manual...!!!

Actually, the 'teardown' took 50 minutes, and the reassembly took
about 3 to 3-1/2 hours.
BUT, for new 'assemblers' plan on 5-6 hours... taking the rig 'down'
gave me a LOT of
pre-assembly knowledge that you'll not have the benefit of when you
do a "from the ground up" build of your K3 kit.

73,

Tom   N0SS

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[AC7AC]

CONTENTS DELETED

The author has deleted this message.