After downloading 1.88/1.70 firmware, I have had problems.
First, I noticed that the receiver came and went on 40M. Then, I switched to 20M and noticed a"ERR PL1" message and found that 20M receive was also acting strange in the same way.
I looked up the "ERR PL1" code in troubleshooting and found that the VCO voltage was out of range. So I went into CONFIG: VCO MD and turned to CAL. K3 went through a CAL sequence. Now I have a
E 00005
ERR VCO
message. Where do I go from here to bring my K3 back to life?
Roger K8RS
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
