QRO = KPA500 and the KPAK3AUX

[AB3EN]

Will the KPAK3AUX have a provision to tap the CTRL line?? I have the PR6 Low-Noise 6-Meter Receive Preamplifier attached to the K3. If not can I get access to the pins in the connector?

"When the control (CTRL) is used and jumper P2 is removed (see Figure 3), the K3 may be configured so
that the preamplifier is switched on only when the 6 meter band is selected."

Any of the Beta testers worked with issue?

Dan
AB3EN

[w0mu]

There was a bit of talk on this and hopefully not having to use two y
cables etc.  I think Elecraft said that this issue would be addressed
with the new cable.

I hope so.

On 4/24/2011 2:09 PM, AB3EN wrote:

> Will the KPAK3AUX have a provision to tap the CTRL line?? I have the PR6
> Low-Noise 6-Meter Receive Preamplifier attached to the K3. If not can I get
> access to the pins in the connector?
>
> "When the control (CTRL) is used and jumper P2 is removed (see Figure 3),
> the K3 may be configured so
> that the preamplifier is switched on only when the 6 meter band is
> selected."
>
> Any of the Beta testers worked with issue?
>
> Dan
> AB3EN
>
> -----
>
> Dan AB3EN
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/QRO-KPA500-and-the-KPAK3AUX-tp6301471p6301471.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html