> 160-10 m are mapped sequentially starting at 0001. 60 m is
> not mapped and will show up as 0000 and 6 m is above 10 m.
> The outputs are open-drain and thus may require pull-ups to
> an external supply in some applications."
>
> Is this the same as the band data output of my FT1000MP ?
Yes. The Elecraft K3 Band Data matches that of the FT-1000MP
and FTV-1000. Neither the K3 or FT-1000MP/FTV-1000 provide
any Band Data output for 60 Meters. The BCD band codes are
1 - A for 160 - 6 Meters. Note: this is different than the
Elecraft KRC2 which uses 1-9 for 160 - 10 meters and assigns
60 meters to A.
73,
... Joe, W4TV
> -----Original Message-----
> From:
[hidden email]
> [mailto:
[hidden email]] On Behalf Of
[hidden email]
> Sent: Tuesday, October 02, 2007 3:53 AM
> To:
[hidden email]
> Subject: [Elecraft] Question about K3 band data on ACC connector
>
>
> The K3 FAQ gives the following info on the band data:
>
> "The default K3 band data outputs match the Unified Microsystems plan.
>
> 160-10 m are mapped sequentially starting at 0001. 60 m is
> not mapped and
> will show up as 0000 and 6 m is above 10 m. The outputs are
> open-drain and
> thus may require pull-ups to an external supply in some applications."
>
> Is this the same as the band data output of my FT1000MP ?
> Currently I am
> using the 1000MP band data to interface with my SPE Expert
> 1K-FA linear. So
> I am just wondering whether I could use the K3 band data
> output instead.
>
> - Enno, PF5X
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
