Tim,
If you see no diagonal lines - then remove NOTHING.
Yes there is a film on both sides of the diffuser, and that is a benefit.
If the rear side has the diagonal lines, then that film should be removed
because the stripes show through.
There is no protective film on the back side of the LCD - it is only on the
front side. You should remove the front film just before putting the front
panel in place - until then, it will protect the LCD surface from scratches
wile you are working on the assembly.
73,
Don W3FPR
> -----Original Message-----
>
> On page 26 of the assembly manual, the 6th step down, it says do
> not remove
> the backing from either side of the diffuser, I assume that means to leave
> the paper backing on that has the writing on it?
>
> Also, I don't thing there is a protective film on the back of the
> LCD, I do
> not see any faint yellow or gray diagonal lines. Would there be
> any film on
> it without the diagonal lines?
>
> Thanks
> Tim
> NZ8J
>
>
> _______________________________________________
> Elecraft mailing list
> Post to:
[hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>
http://mailman.qth.net/mailman/listinfo/elecraft>
> Help:
http://mailman.qth.net/subscribers.htm> Elecraft web page:
http://www.elecraft.com> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.323 / Virus Database: 267.8.1/28 - Release Date: 6/24/2005
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.8.1/28 - Release Date: 6/24/2005
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
