Dale,
The leads come out straight and then bend downward at the location of the
holes - one bend in each lead, and the leads will not be down on the board.
The caution about the capacitors (especially those on the bottom of the
board) is mainly for component mounting height considerations.
73,
Don W3FPR
> -----Original Message-----
>
> I am working on the RF board for the K2 and need clarification for
> Resistor 115, .05 Ohm, 3 Watt. Do the wire leads need to be bent so
> they lie flat on the board? If so, then a 90 degree bend will be
> required immediately at the resistor barrel. Or do the leads remain
> elevated directly above the wire outline on the board? I ask this
> because the instructions make mention of the wire outline on the board
> and recent instructions mentioned the importance of having the
> capacitors mounted as close to the board as possible. Thank you for
> your help.
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
