Hi,
Firstly, thanks to everyone for their help. I have now completed, aligned
and briefly tested 4039 on 20M.
During the course of this final alignment I worked through the set up
procedure for the band pass filters again, using the small broadband noise
generator I have built (Thanks N0SS). But I just did not seem to get the
same easy "peaks" esp. on the lower bands, that I did when I first aligned
it on 40m etc as an RX only (Prior to fitting the SSB board, TX, etc). Is
something wrong?
Thanks !!!
Regards
Nicolas
www.m1hog.com
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (
http://www.grisoft.com).
Version: 6.0.721 / Virus Database: 477 - Release Date: 16/07/2004
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
