RE:D104 use with k2/100

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

RE:D104 use with k2/100

James T. "Jim" Rogers, W4ATK
Linda wrote:
has anyone been sucessful with using the D104 xtal element with the
k2/100,I'm wondering if the preamp will sucessfully make the transformation
from high impedence to low impedence that the k2/100 needs would appreciate
any input..Am Presently using the k2 proset but my audio reports are less
than flattering..John K1GUN
_
        Yes Linda, I use a D104 with my K2/100. There are two versions of the "G"
stand that usually accompanies the D104. One version has an amplifier in the
base. This version with the amplifier is strapable for HIZ/LOZ, LOZ being
the match for the K2. My D104 was not the amplified version, so I built an
"Emitter Follower Amplifier", one transistor, to fit inside the base and
powered the circuit off the 5VDC supplied at the K2 mic connector.
        I did have a problem with RFI on 10meters when running the KPA100 but I
was/am using open wire feeders and RFI is always a possiblity there.
Comments on my audio have been excellent and I am still using the original
crystal element. Some of the users of the D104 have replaced the original
crystal element with a dynamic element from Heil that is a closer match for
the K2. That too works well.
        I have the circuit for the amp somewhere around here. I posted it on the
reflector and several responded with requests for the circuit. I will see if
I can locate it and if so, will e-mail it to you.

73 Jim W4ATK
K2/KPA100 #4028

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com