I resoldered the display. There were some questionable joints.
I also found that during shipping two components on the bottom of the RF
board had come loose, etc. After carefully inspecting the board, cleaning
the flux, etc I found a couple of bridges. Works great now, and I am almost
done with Part 2. Thanks to all who replied.By the way, the Rework
Eliminators are an excellent product, and I highly recommend them.
Mike
AI4NS
I fired up the partially assembled K2 I purchased, and I get an info message
090.Says it is an EEPROM test #1 failed. Also the display is does not show
all segments, and the Tuning knob has no effect. I did a complete reset
with no effect. I am at Alignment and Test Part 1.
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
