Hello, Fellow Elecrafters:
I'm trying to set the offset on my K1 with some degree of precision. I want
to be "on top" of the other station when he' in the peak of my K1 passband.
However, I'm
getting reports that I'm "off", in spite of my best efforts.
My K1 is complete. I flip the switch on the bottom of the RF board. I go
into the
menu, set the ptich to (in my case) 680 Hz, and zero beat the two tones,
using the
capacitor. Then, I flip the switch back to "operate", close everything up,
and I'm NOT zero beat with the other guy. How come this won't accomplish the
job? What am I
missing?
Is it more accurate to use an external receiver to tune in a station, center
that same station in my K1's passband, then adjust the capacitor to place the
K1's transmitted signal on top of the other station (i.e., in the peak of the
passband)?
Any ideas or suggestions would be appreciated.
73, Jim K5HO
---------------------
Nunquam Secundum
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
