On Monday 31 July 2006 at 1842 Jack Lowdon (W4DT) wrote ...
I want to pre-order Rev.G products. How to get the 50% discount on the
order page?
--- - - - ---
Jack,
We did two things when we announced our new rev. G PCB:
1) We permanently lowered the prices of all of our remaining original rev.
D PCB based kits by $4.00. This amount was equivalent to half of the
original price of our "Bare Boards Only" kit, which had been $7.95.
2) We briefly offered a pre-production sale on our new rev. G PCB based
kits at these same prices. That sale was only for one week, and it ended at
1159 UTC on Sunday July 23rd.
--- - - - ---
We had hoped that with sufficient interest during our sale, that we
would have been able to double our production volume and permanently offer
our rev. G based kits at our temporary half-off sale prices. Unfortunately,
interest during the sale wasn't sufficient to do this.
Now for the good news. Our post production rev. G prices are still
lower than our original rev. D based kit prices were, by an average of about
$2.00. We were able to keep our prices so low because our PCB vendor
offered us a generous discount off their standard one-time (Non-Recurring
Engineering) production setup fee.
Even more good news is that our PCB vendor also offered us a two-week
turnaround at their four-week price, so we now anticipate deliveries of rev.
G beginning in early, rather than mid-September as was originally announced.
There's even more good news. Originally, rev. G had ground planes on
just the bottom copper layer. However, after consulting with an RF
Engineer, a second ground plane was added to the top copper layer as well.
--- - - - ---
For even more details, here's the URL of a recent Reflector post
describing some of the differences between rev. G and our original board ...
http://www.ac6rm.net/mailarchive/html/elecraft-list/2006-07/msg00537.html Another 11th hour improvement to rev. G was making the breakaway tabs
20% smaller. This should make it a "snap" to break apart the individual
boards after you've installed and soldered the parts.
73,
Gary, KI4GGX
K2 #4067
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
