Steve,
Solder these jumpers in just as though they were 0 ohm resistorsn nothing
fancy, just a wire to provide a conductiong path. If you install the KAF2
or the KDSP2 you must remove (de-solder) the jumpers and solder the option
headers into the same holes occupied by the jumper leads - so put the
jumpers in with consideration for easiest removal when the time comes.
73,
Don W3FPR
----- Original Message -----
I must not hve the latest version of K2 manual ( Revision E , Feb , 16,2003)
but again I need some more detail explanation as to the Jumper that is
install on the bottom of the control board at the J1 and J2 area which I
understand is part of the audio upgrade after testing the basic K2. Do
these jumpers extend down as the ground jumpers on the top side , right and
left , 5 mm or so ? I dont see any drawings to the effect but assume they
are done the same way across the R18 and 19 outline but just cut. Thanks
for the help.....
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
