the new 10 watt lpa....
Not that I plan on taking the bottom off frequently,
It's ALOT BETTER AND EASIER THAN THE K2,,,,
......and as I did it could only think of the k2's lpa procedure,,,,,
bill #44
>While we're talking disassembly, let me point out that Wayne specifically
>avoided needing thermal pads or complicated hardware stacks anywhere on the
>K3 bottom cover assembly even though the rear section is the heat sink for
>the 10-watt low power amplifier (LPA) module. Pulling the bottom covers is
>simply a matter of removing screws and lifting the covers off. Reinstalling
>the covers involves setting them in place and putting all the screws back
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
