RF Test Part II

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

RF Test Part II

kc5wa
At the risk of being DUMB.

I need some help on my K1.
I'm in the Align & Test Part II
page 46 in the manual
schematic in apendix b

transmit-mode dc voltage measurements:

point to grd___should be______my measurements
J7 pin 1_______5.1-6.7______5.02
J7 pin 4_______5.9-6.1______6.09
J7 pin 6________<.02________5.62
J7 pin 8_______3.8-4.1______4.97

U8 pin 1_______1.3-1.5______0.0
U8 pin 8_______5.1-5.5______0.0

U9 pin 3_______6.0-7.0______.06
U9 pin 6_______6.0-7.0______.34
U9 pin 7_______12-14______12.84

D9 anode_______4.3-4.6______0.0
D9 cathode_____3.8-4.1______4.97
D10  anode_______<.02_______0.0
D10 cathode_____3.8-4.1______4.97
D11 anode_______ <.02_______5.60
D11 cathode_____4.0-4.6______5.01
D13 anode_______0.6-0.7_______0.0
D13 cathode_____<.02______5.61

difficult to put in tune mode suspect
that's just my inabilities still

receiver works fine. I can hear "clicks"
in station rx when keyed.
Thanks for your help....
de "rc" kc5wa

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com