Hi all,
Thanks to all who responed to my question on the VCO
alighment where I only had 8.0 v on the left side of R30 and couldn't
adjust it by L30.
That ended up to be my uneasiness to turn L30. I went to 20 meters
were the voltage was lower than 8v(abt 4.5) and I could see where L30 was working
and saw what direction to adjust it. OK now. It ended up near the top of the can.
New problem is on the IF amp alignment page 64 in manual. I get just
very little hiss with headphones with the AF gain to max and can't even
hear the internaly - generated signal I even hooked up an antenna and
could not hear any signals. I tried tweaking L1 and L2 to no avail...
I was afraid to tweak them to much.
I then tried hooking up the headphone output to the computer mic in ( no
display at all on line in) using Spectorgram and had noise displayed but
no trace of a signal , by the way the mic gain was in the middle. Then
i tried tweaking L1 and L2 but could see no change. Should I be able to
see the internally generated signal with spectrogram?
Every adjusment on pages 60 to 63 went ok.
Just got my XG! test occilator today and put it together tonite and did a little troubleshooting.
I have the K2 set for 7040 Khz and the XG1 on 50uv and i am getting at the W2 jumper a 42 mv p-p 11955khz signal (using a scope and the internal freq counter). There is nothing at the W3 jumper, not getting thur the crystal filter. BUT, should not that be a 4.9136 IF signal? I get the same freq signal at the collector of Q22, the post-mixer amp.
Anyone have any suggestions or am I barking up the wrong trail.
Tnx again in advance .
Jerry n2uz
[hidden email].
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
