Re: Bad joints on KPA100

[Robert C.Abell]

Gerhard,

Do NOT scrape the tinned pads. Your problem is due to insufficient heat.
I hope you are using an adjustable soldering station.
Increase the heat to 400 degrees C.
Good luck!

73, Bob  VE3XM
K2  S/N  02676
K2/100  S/N  04031
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com