Problem solved (so far)! I removed all cables from the K3, opened the
top and re-seated all the TMP connectors. When removing the cables I
noticed the screws holding the RS232 connector were loose and the
connector was very slightly unseated on the left side. After putting
everything back together the K3 was transmitting normally again. After
several on/off cycles during the day it seems OK. Thanks for all the
suggestions.
It was good to hear Eric say all the Elecraft employees are safe!
Hopefully their homes are, too.
Jim W6YA
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
